Feature
Total solution marine electronic compass
4 Digit LED Heading Display readout
Analog heading indication by a rotating LED light.
Accuracy up to +/-0.1 degree
Provides 2 NMEA0183 heading outputs
Electrical interface of output ports supports RS232, RS422 and RS485
Wide range power sup..
Specially designed for use in a marine environment with IPX2 water protectionWi-Fi to send to tablet/phone etcWi-Fi input/output, 1 WAN + 4 x LAN ports for direct connection of equipment using standard network cablesIPX2 water protection (IPX2 = protected against spraying water when tilted up to 15 ..
This device is often used with a KAP 866 Auto Pilot to drive a reversing motor or pump that requires a single input connection that swings both positive and negative. KAP866 has two positive outputs, 1 output driving the rudder left and the other to the right. This solid state device will convert th..
This is all you need to connect your Onwa 0183 chart plotter to an NMEA2000 installation. Data conversion can be in both directions and the built in wi-fi function is ideal for use with Navionics Boating App to view AIS targets on a phone or tabletNMEA0183 to NMEA2000 &nbs..
This Ultrasonic Anemometer has no moving mechanical parts so no bearings to seize. It works by simultaneously measuring the 2-dimensional horizontal components of the wind speed and direction based on principle of TOF (time of flight) of ultrasonic sound wave.The anemometer is made in moulded thermo..
An advanced fixed VHF with the benefit of its own internal GPS, IP67 water protection and ATIS. ATS? - for anyone planning a trip using European inland waterways and canals ATIS is a legal requirement - this VHF has it. Somewhat similar to AIS it is an automated system that transmits your boat detai..
The 9 axis Heading Sensor looks like a conventional GPS but the similarity ends there. Inside its IP67 case there is a very sophisticate device that can calculate SOG, COG, position and heading, pitch, roll and yaw and it does all of these rather well. From switch on, it gets a heading in just a few..
A 2 pin DC supply cable for 99 series chart plotters. Cable length = 1.8 metres, can be used on DC 12 and 24 volt systems. Longer cable lengths can be supplied, please ask. This cable doesn't have a fuse as the plotter has its own replaceable fuse.Please note that conductor colour for DC positive su..
Connection information:
Yellow NMEA0183+ into plotter from other equipment
White NMEA0183 - into plotter from other equipment
Blue NMEA0183 - to other equipment
Orange AIS out to other equipment
Green &n..
The traditional 'mushroom' shaped GPS aerials use a connector known as a BNC which is a push and twist device (there is a similar TNC which is a screw on connector but is quite rare and mainly found on Furuno GPS aerials).The Onwa 5 and 7 inch plotters have a small connector known as an SMA connecto..
The new small Puck type GPS aerials have a connector known as an SMA connector: - this will connect directly to Onwa 5 and 7 inch plotters, however, 8 and 12 inch models and also the KS-200A AIS Black Box transceiver needs a BNC type.This adaptor will convert the SMA connector to a BNC Price in..
Onwa KS33-NT AIS Tracker Can have many uses but primarily used to track and locate pots and nets. Transmits an encoded (only the owner can track it) signal on the AIS frequencies in the marine VHF band.
One Touch SART button (open the cover to show the SART button)
High transmit power, 12.5 W..